For the engineer · assembly check
The product range, as a document you can keep
A 12-page A4 overview: series index, section data, tolerance classes, finishing and commercial terms. Built from the parameters published on the product pages, not from a marketing brief.
Aluminium extrusion product range
Includes the 30 category slugs, 42 selected cross-sections with slot geometry and weight per metre, alloy and temper range, execution standards, finishing films, and the terms a purchasing file needs.
Read the scope line. This is an overview, not a certified test report. Certificate numbers, certificate scans and per-section DXF geometry are not in it — those are issued per project against a drawing.
For QA · filing and verification
The standards a specification has to name
A quote that says “±0.1 mm” without naming a class is not a specification. These are the references used on our capability pages, grouped so your QA can file them against an order.
Dimensional
- EN 755-9
- General-purpose extruded profile tolerances — the default class
- EN 12020-2
- Precision profiles in 6060 / 6063 — a tighter class
- GB/T 6892
- Chinese national standard for extruded profiles
Surface
- ISO 7599
- Anodizing of aluminium — general specification
- Qualicoat Class 1
- Powder coating performance class
- AAMA 2604 / 611
- Powder and anodized architectural finishes
Material and system
- EN 573
- Chemical composition on the material certificate
- ISO 2409 / 9227
- Cross-cut adhesion and neutral salt spray
- ISO 9001:2015
- Quality management system — certificate details supplied per project
Note the distinction: EN 755-9, GB/T 6892 and the finish standards are execution standards, not certificates. They describe what a part is made to; they do not certify a factory.
For the buyer · before you quote
Six items that answer almost every feasibility question
Send these together and you get a written feasibility reply in one working day, including a written “no” if the section will not run.
- Cross-section drawingCAD, dimensioned PDF, or a hand sketch with numbers on it
- Alloy and temperDefaults to 6063-T5 if not specified
- Estimated annual quantityDecides whether tooling is a real cost per ton
- Finish requirementMill, anodize or powder, with a colour reference
- Tolerance class and critical facesEN 755-9 or EN 12020-2, and which dimensions are fit-critical
- Length, machining and packingAny cut, drill, tap or assembly after extrusion
Honest inventory
What is not here yet
A downloads page that lists only strengths is not usable for a sourcing decision. These are the gaps, stated plainly.
- Per-section DXF files
- Geometry for individual cross-sections, starting with the 40 series. Needed for a real assembly check in CAD.
- Certificate scans
- ISO 9001 certificate number, issuing body, validity and scan, plus sample FAI and material certificates.
- Third-party test reports
- Salt spray and accelerated weathering are run at an accredited laboratory under its own name, not in-house.
- Case data
- Project references with quantities and measured results, anonymised where the customer requires it.
on request
supplied per project
supplied per project
not published
If one of these is what you actually came for, ask for it directly. We would rather say what exists than let you find out at first article.
